Published: 2021-08-09 10:41:03 - Exported: 2024-09-04 16:42:53 | NB | The information on this sheet once printed/exported is classed as an uncontrolled copy. The currency of the information should be checked by visiting the ESFG website prior to using the information for any purposes.

Published: 2021-08-09 10:41:03 - Exported: 2024-09-04 16:42:53 | NB | The information on this sheet once printed/exported is classed as an uncontrolled copy. The currency of the information should be checked by visiting the ESFG website prior to using the information for any purposes.

Published on NSW Department of Education - EFSG (https://dec-staging.sitback.com.au)

SG315

Concrete - Finishes

GUIDE NOTE: Refer to Design Guide sections DG/ FABRIC, DG/ STRUCTURE, DG/ MATERIALS AND FINISHES, DG/ FLOOR

ID
Title
Compliance Level
Expand All
1
General
Mandatory
Mandatory

As per current NATSPEC except as follows:

1.6 Tolerances
 
GUIDE NOTE: Delete the flatness tolerance class table in the NATSPEC Building Template/Worksection and replace with the following: 

Class

Measurement

Maximum Deviation (mm)

A

Maximum deviation from a 3m straight edge

3

B

Maximum deviation from a 3m straight edge

6

C

Maximum deviation from a 600mm straight edge                                                              

6

 

2
Products
Mandatory
Mandatory

As per current NATSPEC.

3
Execution
Mandatory
Mandatory

As per current NATSPEC.

GUIDE NOTE:  Provide a fall of 1:200 to floor wastes in concrete slabs under timber floors (e.g. sprung floor in school halls) to drain water.  Refer to SG / SHEET FLOORING & DECKING
4
Selections
Mandatory
Mandatory

As per current NATSPEC.